From Cyberdine Graphics, the global leader in the manufacturing of Raised inserts for Corvette vehicles. When you buy our inserts, you're certain to get the absolute very best there is in the market. No cost is spared in the manufacturing process.

After a year of studies and trials Cyberdine has achieved their goal which was to bring you inserts that would surpass quality not found even on OEM emblems. They are the BEST adhesive inserts on the market, period.

We also offer free shipping on all insert orders.

*****Install Instructions***************
Clean surface with a mild detergent or dish washing fluid until you completely remove all grime and oily residues left behind from Armoral or similar products. Clean it regardless of weather you used Armoral, similar products or not. Failure to do so will result on insert poor adhesion which will follow.
We advise you to install a piece of scotch tape on the surface to test how clean your dash really is. If scotch tape doesn't stick well to your dash surface than that means that further cleaning is necessary. Repeat cleaning procedure until you get a desired result. Only then you should attempt to install the insert, as you don't want to ruin the adhesive on your insert. Safe install between 60° to 80° with 40% to 50% or less humidity is needed for proper adhesion.
* Clean steering wheel with mild detergent to remove all oil and grime.
* If Amoral has been previously applied to surface area, further cleaning with stronger detergent will be needed.
* Align insert over the grooves on your corvette's steering wheel and apply it over.
* After installation insert looks small or out of place, re-alignment will be necessary. Insert will is made to make a perfect fit.
Failure to properly clean the area prior to application will result in poor adhesion of insert. No Free replacements will be given for improper installation.
* Don't forget to read SUMMER CONDITIONS at the bottom

Humidity is no more than water particles in the air, and when the air is saturated with water at a high percentage it will affect not only the effectiveness if the adhesive agent of inserts just as of any other adhesive in general. Not only that but our vehicles run hotter and so does aircraft and even us humans get affected by this natural phenomenon. Therefore in Summer weather mostly this will be a factor in most states in the US. As humidity can be a factor on a successful installation we must advise you of its effect on any insert installation.

You should only install any insert when the weather is cool and almost no humidity, open your vehicle windows and allow it some time to ventilate throughtout it. Dry or nearly dry weather would be the perfect climate. If current weather in your area is carrying high humidity, it would be suggested to wait a few days until humidity percentage lowers to 40-50% Heat itself should not be a factor on a successful installation.