Corvette C6 Intake Halltech Venom II
The Halltech C6 Venom II is next evolution of intakes for the Corvette C6 Base Car with the LS2 motor. Bolt on 15 RWHP/12 lbs ft torque with our all new Corvette C6 LS2 intake design. This Corvette C6 intake is made from the same mold as the Killer Bee II that dynoed +15 HP/+14lbs-ft. on the Katech Engine Development Superflow dyno. The same huge high flow K&N Filter will flow over 1250 cfm, and feeds over 900 HP easily. This system uses the stock wiring, and MAF sensor for direct bolt on power that will not void your warranty. It comes with Halltech's Beehive Heat Shield to isolate the filter from engine heat and capture cold air with optional cutouts for cold air induction.
The new filter has a positive stop built into the flange to eliminate the step ingress to the bridge for smoother flow. It also has the latest technology for high velocity flow through the filter with a bellmouth designed flange. Please note this intake is not compatible with 2008 and beyond models! Click here for 2008 LS3 Corvette Intake
Estimated HP increase is 9-15 HP over the stock airbox. Your Corvette intake and exhaust system are two of the easiest ways to add Horsepower to your Corvette. Don't skip on either one, get the best you can afford.
Free shipping in the lower 48 states.
Installation Instructions are located here.
- 14 to 16 RWHP
- Killer Bee ISO 5011 Filter
- Velocity Stack Flange
- Smoothbore Silicone Connector Hose
- 15 minute Installation
- Uses Stock Delphi MAF Sensor
- Requires NO Reprogramming
- Matches the LS7 Airflow
Want to really get the most out of your intake? Make sure you add Vette Air ram air port to go with your new intake. More info here, Corvette Vette Air Intake
|
